HearthRite HRSQ25MV, Руководство пользователя и инструкции по эксплуатации

Страница: 13 / 32

13 Vent-Free Gas Stove User’s Manual
Installation (cont.)
INSTALLING THE BLOWER (OPTIONAL, Model HAQBLR)
1.
NOTE:
Ensure the rocker switch is positioned in the upper left
corner. (see Fig. 6b).
This blower is equipped with manual AUTO/OFF/MAN switch
(see Fig. 7). AUTO allows blower to automatically come on and
off. MAN allows the blower to run continuously.
NOTE:
If any of the original wire supplied with the heater must be
replaced, a wire of at least an equal temperature rating must be
used. Refer to Fig. 8 for the wiring diagram.
Electrical grounding instructions: This appliance is
equipped with a three-prong (grounding) plug for
your protection against shock hazard and should be plugged directly into
a properly grounded three-prong receptacle (See Fig. 4).
WARNING
Fig. 5—Blower Panel
Fig. 6b—Attaching the Blower
Fig. 4—Grounded Three-
Prong Receptacle
Label all wires prior to disconnection when servicing controls. Wiring errors can cause
improper and dangerous operation. Verify proper operation after servicing.
CAUTION
Fig. 7—Operating the Blower
Do not use a blower insert, heat exchanger insert or
other accessory not approved for use with this heater.
Rocker
Switch
Grounded
Three-Prong
Receptacle
Disconnect the stove heater from the gas supply before installing
the blower accessory. Contact a qualified service person to do this.
Remove the blower cover plate using a screwdriver (see Fig.
5). Save the screws for attaching the Blower
WARNING
2. Attach the blower air housing to the inside baffle panel using
the screws provided. (See Fig. 6a).
3 Attach the blower to the rear panel of the stove heater using
the eight screws removed earlier. (See Fig. 6b).
4. Plug the power cord into a properly grounded three-prong
receptacle (see Fig. 4).
Fig. 6a—Attaching Air Housing
Fig. 8—Blower Wiring Diagram