Hearth Products F-0710X1 series, Инструкция для пользователя, по установке и обслуживанию

Страница: 14 / 23


14
Install the ceramics and the glass panel to the appliance according to these instrucons—see pages 13 and 20
Test the operang pressure of the appliance by aaching a pressure gauge to the test point of the appliance.
This connecon should take place when the appliance is OFF. Ensure that gas is turned on at the gas meter and
purge the air from the appliance by :
MANUAL CONTROL UNITS:
Rotang the control to the (IGN) posion and
push in. Push the igniter buon situated at the
boom le side of the appliance, the pilot should
light. If the appliance does not light aer 10 seconds
the knob should be rotated back to the (OFF)
posion and back to the IGN posion to generate
the spark at the electrode Check that the spark is
being generated correctly at the pilot assembly.
Connue with this procedure unl the air is purged
from the appliance and the pilot is lit. Once lit hold
the valve pushed in for up to 10 seconds. Once the
pilot is established and secure, turn the control knob
an-clockwise to the (HIGH) posion. Allow the
appliance to run for a minimum period of 5 minutes.
Next check that the inlet pressure to the appliance is
at 20 mbar ±1 mbar.
SLIDE CONTROL UNITS:
Push down the control lever fully to the (IGN) posion and
hold. The spark generator should spark connuously, ensure
the spark is being generated correctly at the pilot assembly.
Connue with this procedure unl the air is purged from the
appliance and the pilot and main burner are lit. Once lit hold
the lever pushed down for up to a further 10 seconds. Once
the pilot is established and secure allow the lever to rise to the
(LOW) posion then li the lever to the (HIGH) posion.
Allow the appliance to run for a minimum period of 5 minutes.
Next check that the inlet pressure to the appliance is 20 mbar
±1 mbar.
It should be noted that the slide control appliance will light the
pilot and main burner during the ignion process. The
customer should be advised of this fact.
The flames will appear blue unl the appliance reaches temperature. This can take between 10 and 20 minutes.
The customer should be advised of this fact.
If the appliance is exnguished or goes out, wait for 3 minutes before aempng to relight the appliance.