7019-801C
July 10, 2019
21
SANTA FE PELLET INSERT
E. Adjustable Hearth Support
Size: 9”d x 45”w, 2” to 10” Height Adjustment
1. The 10 screws on each set of scissors will already be
loose when shipped
(Figure 21.1)
.
2. Expand scissors to desired height. Tighten screws
to hold in place using Phillips head screwdriver
(Figure 21.2)
.
3. Measure front and side trims to required height to
cover scissors and mark pieces for cutting. Cut excess
material from top of trims edge, not bottom. This edge
will be sharp; wear gloves to prevent injury to your
hands
(Figure 21.3)
.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fits under lip of top trim, so it allows
for some variance in your straight edge.
5. The double-sided tape that holds front and side trims to
scissors has a powerful bonding adhesive. Adjustments
are extremely difficult once trim has adhered to tape.
Do a dry run first without removing paper from tape.
6. Place cut edge of trim under top lip and into position
on scissors. Place side pieces on first and then front
piece. The front piece overlaps side pieces.
7.
Once you are satisfied with the positioning, remove trim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece. Repeat for other side. Install
front trim piece last.
9.
There are 3 holes in the back flange of the top to
secure it to the wall if necessary. Use the appropriate
fastener for the type of wall material, i.e., brick, sheet
rock, etc.
Figure 21.1
Figure 21.2
Figure 21.3
Figure 21.4
NOTE:
3/8 inch (9.5mm) thick tile or like material can be
cut to size and fit under lip of top trim edge for a
decorative touch
(Figure 21.3
).
DOUBLE-SIDED TAPE
DOUBLE-SIDED TAPE
SCREWS ARE CIRCLED
EXPLODED VIEW OF SCISSORS
Decorative tile may
be installed
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED HEIGH T
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
WARNING
Sheet metal trim edges will be sharp. For
safety purposes wear gloves.
Injury can occur.
Содержание Quadra-Fire SANTA FE SANTAFEI-C
Страница 27: ...7019 801C July 10 2019 27 SANTA FE PELLET INSERT Date of Service Performed By Description of Service...
Страница 28: ...7019 801C July 10 2019 28 SANTA FE PELLET INSERT Date of Service Performed By Description of Service...
Страница 29: ...7019 801C July 10 2019 29 SANTA FE PELLET INSERT Date of Service Performed By Description of Service...
