1
Hearth & Home Technologies • RC150 IntelliFire
™
Touch Installation Instructions • 2326-980 • 9/16
Leave this manual with party responsible for use
and operation.
IFT-RC150
IntelliFire
™
Touch Remote Control
Installation Instructions
1. Introduction
The IFT-RC150 is a wall mounted device that is designed
to control the functions of Hearth & Home Technologies
products equipped with IntelliFire™ Touch Technology
(IFT). It can be used to control the ON/OFF functions of
the flame and cold climate modes of the appliance.
2. IFT-RC150 Installation
A. Precautions
This device is tested and safe when installed in accor-
dance with this installation manual. Do not install any
components that may be damaged.
Do not modify, disassemble, or substitute any of the com-
ponents included with this kit. Installation of this unit must
be done by a qualified service technician.
The location of this device may affect performance. An
assessment of the location should be done prior to instal-
lation for optimum performance.
Hearth & Home Technologies disclaims any responsibility
for, and the warranty will be voided by, the following actions:
• Installation and use of any damaged system component.
• Modification of the system component.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fire hazard.
• Read, understand and follow these instructions for safe
installation and operation.
B. Determine Location
Determine the location for the IFT-RC150. The selected
location should be in the same space as the gas appli-
ance with visual sight of the appliance. The device must be
placed within 30 feet (9.14m) of the appliance but should
not be exposed to extreme heat.
The IFT-RC150 is approved for interior installation and
should not be used in exterior applications.
• Keep remote control out of reach of children.
C. Wall Mount Kit Contents
• IFT-RC150 Wireless Wall Switch
• Radio Frequency Module (IFT-RFM)
• 1 inch #6 Screws (2)
• Drywall Anchors (2)
• AA Batteries (2)
D. Installation Steps
1. Remove the contents from packaging.
2. Locate the IntelliFire™Touch electronic control module
(IFT-ECM) in the control cavity of the appliance and
move the three-position switch to the OFF position.
See Figure 1.
3. Connect the IFT-RFM to the IFT-ECM by aligning the
pins and tabs and pushing the IFT-RFM into the IFT-
ECM until both tabs latch into position. Ensure the
two components are fastened securely to one another.
See Figure 1.
Figure 1. Connect IFT-RFM to IFT-ECM
CAUTION! Do not install damaged components. If you
received components that are damaged, contact your
dealer for assistance.
CAUTION! Risk of burns! DO NOT program the wireless
wall switch to the IFT-ECM when appliance is hot.
‘OFF’ POSITION
