12
Hearth & Home Technologies • SMART-BATT-II Remote Control Instructions • 100-909 Rev. i • 5/12
Limited Warranty
This REMOTE CONTROL SYSTEM is warranted for 12
months from the date of purchase or installation to the
original purchaser to be free from defects in materials
and workmanship. Damage to the SYSTEM caused by
accident, misuse, abuse, or installation error whether
performed by a contractor, service company, or owner, is
not covered by this warranty. Seller will not be responsible
for labor charges and/or damage incurred in installation,
repair, replacement or for incidental or consequential dam-
ages. Batteries and any damage caused by them are not
covered by this warranty.
Some states, provinces, and nations do not allow exclu-
sion or limitations of incidental or consequential damages,
so the above limitations or exclusions may not apply. This
warranty gives you specifi c legal rights. You may have other
rights that vary by state, province or nation.
• Cause the RF signal to get lost and not communicate
with the receiver.
• Cause the working distance to be shorter than normal.
Specifi cations
Batteries: Transmitter - 3V 2 ea.; AAA 1.5V, Alkaline
Receiver: (4) AA I-SV Alkaline
Operating Frequency: 433.92 MHZ
FCC ID No.’s: ULERF-5AN
IC No.’s: 6732A-RF5AN
Service Parts
No service parts available.
Troubleshooting
To check the operation of the remote:
1. Make sure receiver batteries are installed properly.
If one battery is installed backward, receiver will not
operate in remote mode. Be sure battery output is 5.3
volts or more. (Slide switch is independent of battery
condition).
2. Be sure the transmitter’s batteries are properly installed
and that the battery output is 2.7V or more.
3. Check to make sure the transmitter is communicating
with the receiver.
• If the receiver beeps when the MODE button is
depressed on the transmitter they are communicat-
ing.
• If the receiver does not beep when the MODE but-
ton is depressed on the transmitter go to Matching
Security Codes.
4. Make sure the transmitter is within the 20 feet range of
the receiver.
5. Positioning of the receiver is important. If the receiver
is “enclosed” in a metal surround, the operation of the
receiver may be affected as noted below. Reposition the
receiver to improve operating range. It is suggested that
a heat shield be installed to protect the receiver from
extreme heat. If the receiver is “enclosed” in a metal
surround, this can:
Please contact your Hearth & Home Technologies
dealer with any questions or concerns.
For the location of your nearest
Hearth & Home Technologies dealer,
please visit www.fi reside.com.
Hearth & Home Technologies Inc.
7571 215th Street West, Lakeville, MN 55044
www.fi reside.com
