Hearth & Home Technologies • Gas Conversion Instructions for Courtyard • 4608-904 Rev. C • 01/2020
2
Converting Gas Control Valve
1. Locate the gas valve. Using a #20 tamper-proof Torx
screwdriver, remove the regulator and rubber gasket
on face of valve. See Figure 2. Discard both the
regulator and rubber gasket.
2. Install the new regulator along with the new rubber
gasket included in the conversion kit. See Figure 2.
3. Place the gas type label on the appliance adjacent to
rating plate. Ensure the gas type label is appropriate
for the type of gas to which you are converting the
appliance.
Note:
The qualified service agency installing this conversion
must enter the day, month, and year, and sign the propane
conversion plate added to this appliance.
Fire Risk
Explosion Risk
Gas Leak Risk
WARNING
• Rubber gasket must be seated properly on valve face.
• Do not install a valve or regulator that has been dropped.
Figure 1.
Rubber
Gasket
Regulator
Valve
#20 Torx Screws
Before You Start
This conversion shall be installed by a qualified
service agency.
Any damaged valve components should not be
installed. If a valve or regulator has been dropped
or appears to have been modified, the valve or
regulator should not be installed.
KIT CONTENTS
Gas Valve Regulator
with Rubber Gasket ....................................One (1)
Pilot Orifice
...................................................One (1)
Conversion Plate ..........................................One (1)
Gas Type Label ............................................One (1)
Burner Orifice
.............................................. One (1)
Installation and service of this appliance should be performed by
qualified personnel. Hearth & Home Technologies recommends
HHT Factory Trained or NFI certified professionals.
Accessing Gas Control Valve
NOTE
: The valve compartment must be accessed
through the firebox of the appliance.
1.
Turn off gas supply at external shutoff and allow
the unit to cool (required).
2. Disconnect power at GFCI circuit breaker
(required).
3. Remove logs or glass and vacuum media from
unit.
4. Remove six (6) screws securing cover assembly
from appliance, set aside. See Figure 1.
5. With the cover assembly removed, the tamper-
proof torx screws can be accessed to remove
the regulator. See Figure 1.
Figure 2.
Valve Regulator Conversion
