Hearth & Home Technologies • GFK-160VF Fan Kit Installation Instructions • 4136-920 • Rev C • 8/22
1
GFK-160VF Fan Kit
Installation
Instructions
This fan kit has been tested for use with specific Hearth & Home Technologies products. Check with your local build
-
ing code agency before you begin installation to ensure compliance with local codes, including the need for permits and
follow-up inspections. If you encounter any problems regarding code approvals, or if you need clarification of any of the
instructions contained here, contact your Hearth & Home Technologies dealer. For the dealer nearest you, please visit www.
hearthnhome.com.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during installa-
tion. Sheet metal edges are sharp.
The GFK-160VF fan has been designed to circulate room
air through the firebox or appliance or appliance to enhance
heat output. The GFK-160VF fan system operates on 120
VAC, 60 Hz power. This is available through a receptacle in
the factory installed junction box. The junction box is locat
-
ed in the controls compartment of the firebox or appliance.
A variable speed control is provided with the fan system to
provide quiet forced air flow at the desired speeds. A tem
-
perature sensor switch, which automatically turns the fan
ON/OFF is also provided with this kit.
Introduction
NOTE:
The variable speed control and temperature
sensor switch are not used with some remote control
systems.
Compare system components in Figure 1 with the actual
parts received. If any parts are missing or damaged, con
-
tact your dealer before starting installation. Do not install a
damaged light kit.
Kit Contents:
CAUTION!
Do not install damaged components.
Figure 1. System Contents
1. Speed Control
7. Wire Clips (2)
2. Fan
8. Control Knob & Nut
3. Air Deflector (2)
9. Wall Box Plate
4. Power Cord
10. Instructions
5. Screws (4)
11. Wire Harness
6. Magnets (2)
12. Temperature Sensor
13. Foam Tape (2) Not
Shown
Installation Precautions
The GFK-160VF Fan Kit is tested and safe when installed in
accordance with this installation manual. It is your respon
-
sibility to read all instructions before starting installation and
to follow these instructions carefully during installation to as
-
sure maximum benefit from, and safe operation of the fan.
This fan is carefully engineered and must be installed only
as specified. If you modify it or any of its components, you
may cause a fire hazard and will void the WARRANTY. In
addition, such action may void the coverage provided by the
owner’s home insurance.
CAUTION!
All wiring should be done by a qualified
electrician and shall be in compliance with local codes
and with the National Electric Code ANSI/NFPA NO.
70-current (in the United States), or with the current
CSA C22.1 Canadian Electric Code (in Canada).
Installation Instructions
WARNING: Risk of Shock! Turn electrical power off
at the circuit breaker before beginning this installation.
NOTE: The factory installed junction box in the fire
-
box or appliance must be wired with 110 VAC before
installing this kit. See firebox or appliance Installation
Instructions.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Service Parts
Part Number
Description
SRV4137-306
Power Cord
SRV4137-304
Wire Harness
SRV4137-128
Air Deflector
SRV4121-119
Wall Box Plate
100-510A
Speed Control
SRV230-0060
Temperature Sensor
