7
3. Identify the Left Upright (88), which is marked
with a “Left” sticker or an “L” sticker. Have a sec-
ond person hold the Left Upright near the Base
(91).
See the inset drawing.
Tie the wire tie in the
Left Upright (88) securely around the Upright
Wire (77) about 8 in. (20 cm) down from the
end. Then, pull the other end of the wire tie until
the Upright Wire is routed completely through
the Left Upright. Note: The Upright Wire should
bend so that the connectors are pointing down-
ward.
1.
Make sure that the power cord is unplugged.
Place a piece of cardboard below the rear of the
Frame (57) to protect the floor or carpet.
Attach the Left Wheel Cap (92) to the Base (91)
with two #8 x 3/4" Screws (2).
Attach the Right Wheel Cap (not shown) to
the right side of the Base (91) in the same
way.
1
92
91
2
57
Cardboard
2. Pull the Upright Wire (77) and the Ground Wire
(90) through the indicated hole in the Base (91).
Attach the Ground Wire (90) to the Base (91)
with a #8 x 1/2" Ground Screw (10).
Press the Grommet (75) into the square hole in
the Base (91).
77
2
75
Hole
10
90
91
77
3
77
88
Wire
Tie
88
91
77
Wire Tie
