ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. If assistance is needed,
please call our Customer Service Department at 0345-089009.
Assembly requires the following tools: the included allen wrench, a phillips screwdriver ,
an adjustable spanner , a rubber mallet , and pliers .
During assembly, use the drawings below to identify the small parts used in assembly. The number in parenthe-
sis below each drawing refers to the key number of the part, from the PART LIST on page 18. The second num-
ber refers to the quantity used in assembly. Note: Some small parts may have been pre-attached. If a part is
not in the parts bag, check to see if it has been pre-assembled.
5
1. Hold the Rear Stabiliser (65) against the saddle on the
rear of the Frame (1). Make sure that the Rear
Stabiliser is turned so the square holes are facing away
from the Frame. Attach the Rear Stabiliser with two
M10 x 105mm Carriage Bolts (27) and two M10 Nylon
Locknuts (26).
1
26
26
1
27
65
2
2. Turn the Resistance Control (57) counterclockwise to
the minimum setting.
If the Resistance Control (57) is attached to the Upright
(2), remove the M4 x 16mm Screw (35). Pull the bot-
tom of the Resistance Control away from the Upright
and then slide it down to remove it.
57
Tab
2
35
M10 x105mm Carriage Bolt (27)–2
Axle Screw (30)–2
M10 x 85mm Bolt (25)–1
Nylon Washer
(11)–2
M8 Split
Washer (58)–2
M8 Washer (81)–6
M4 x 16mm
Screw (35)–9
M4 x 16mm
Flange Screw
(43)—6
M8 Nylon
Locknut (80)–2
M10 Nylon
Locknut (26)–7
Spacer
(44)–4
M8 x 108mm Button Head Bolt (79)–2
All manuals and user guides at all-guides.com
