22
Inspect and properly tighten all parts of the elliptical
exerciser regularly. Replace any worn parts immedi-
ately.
For smooth
operation of the
elliptical exer-
ciser, inspect
and clean the
ramp regularly
using a soft
cloth and mild
detergent.
Other parts of
the elliptical
exerciser can
also be cleaned
in this way. Keep liquids off the console. Never use
abrasives or solvents.
PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function proper-
ly, see step 6 on page 13.
HOW TO CALIBRATE THE INCLINE SYSTEM
If the elliptical exerciser’s incline system is not working
properly, activate the calibration process by following
the steps below.
1. Hold down the Start button and the Heart Rate
increase button at the same time for about five
seconds. Note: Numbers may appear in the dis-
play; disregard these numbers.
2. Press the Start button again. Note: A combination
of letters and numbers will appear in the display.
3. Press the 30° 1 Step Ramp button. The ramp will
rise to the highest position and then sink to the
lowest position.
4. Press the Start button three times. The console
will then be in the normal operating mode and the
elliptical exerciser will be ready for use.
HOW TO MOVE THE ELLIPTICAL EXERCISER
Stand in front of the elliptical exerciser, hold the frame
firmly, and place one foot against the ramp in the
location shown below. Pull the frame until the elliptical
exerciser can be moved on the front wheels, and
carefully move the elliptical exerciser to the desired
location. Then, place one foot against the ramp, and
lower the elliptical exerciser. Due to the size and
weight of the elliptical exerciser, use extreme cau-
tion while moving and lowering it.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
If the elliptical
exerciser rocks
during use, turn
one or both of
the leveling feet
under the rear
stabilizer until
the rocking
motion is elimi-
nated.
MAINTENANCE AND TROUBLESHOOTING
Ramp
Leveling
Foot
Frame
Wheel
Place your
foot here