9
10. Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the
elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.
8. Apply a thin film of the included high-temperature lubri-
cant to both Pivot Shafts (15).
Identify the Right Handlebar (9), which is marked with
a sticker. Apply a small amount of grease to the axle
on the Right Handlebar, to the Pivot Arm Cover (64),
and to the Inner Upright Cover (63).
Next, slide the Right Handlebar (9) onto the right Pivot
Shaft (15), and insert the axle on the Right Handlebar
into the Right Upright (3). Note: Position the Right
Pedal (13) near the top of the Ramp (5). Then, lift
and push the Right Pedal sideways, toward the
center of the Ramp, to insert the axle into the
Right Upright.
Next, slide a Wave Washer (100) onto the end of the
axle on the Right Handlebar (9). Apply a small amount
of grease to an M8 x 28mm Washer (99), slide the
Washer onto an M8 x 25mm Button Screw (81), and
tighten the Button Screw into the axle. Then, attach an
Outer Upright Cover (74) to the Right Upright (3) with
two M4 x 25mm Screws (105).
Attach the Left Handlebar (10) to the left Pivot Shaft
(15) and the Left Upright (4) in the same way.
9
15
Lubricate
3
13
74
100 99
9. Plug the Power Cord (8) into the Power Receptical
(68) at the rear of the elliptical exerciser.
Next, plug the Power Cord (8) into an appropriate
outlet as described on page 10, and calibrate the
elliptical exerciser’s incline system by following
the steps on page 22.
8
68
9
8
63
64
81
105
10
5
4
Grease
15
Lubricate
Axle
