HeadHunter X-CALIBER XR-124, Инструкция по установке и эксплуатации

Страница: 14 / 16

Doc No. XG-0042 Rev No. 042808
13
Troubleshooting Guide:
Problem Cause Remedy
Pump runs continuously or a. Leak in discharge piping. * Fix leak.
cycles on and off. b. Debris stuck in inlet check valve. * Clean debris out of check valve.
c. Inlet check valve is missing. * Install check valve.
Pump stops because of alarm condition a. Dry running. * Check the water supply.
b. Overheating. * Supply cold water<95F (35C)
c. Over or under voltage. * Check electrical supply.
d. Anti-flooding shutdown. * Disable if not required.
e. Over Pressure Alarm * Reduce inlet pressure to the pump.
f. Over current alarm. * Free blocked rotor/impellor.
g. Over temperature of electronics. * Reduce ambient temperature.
Pump does not reach max pressure.
a. Low voltage, pump operating in 300W
emergency power mode.
* Check electrical supply.
b. Air leak in suction line. * Repair leak in suction line.
c. Restriction in suction line. * Remove restriction in suction line.
d. Pump not fully primed. * Prime pump.
e. Pump set for wrong power setting.
* Check wiring, and circuit protection
then increase power setting.
Technical Support:
Have a question about the X-Caliber, or need technical advice? Contact your nearest Headhunter representative or our technical
support department via;
Toll Free Phone in the USA:
(800) 662-8557
Outside or inside the USA Phone #: (954) 581-6996
Email:
headmaster@headhunterinc.com
Fax: (954)-587-0403
Limited Warranty:
Headhunter warrants its XR-124 and XRS-124 X-Caliber water pumps to be free from material and workmanship defects under
normal use and service for a period of two (2) years from the date of manufacture. Headhunter will repair or replace, at its
discretion, any part of the X-Caliber Water Pumps, which were determined to be defective by the factory provided that:
1.
The product has been properly installed and used in accordance with the instructions packed with the product.
2.
No repairs have been made without written factory authorization.
3.
Proof of purchase can be provided.
4.
The product has not been misused, abused or altered in any way.
5.
The product or component has been returned for warranty evaluation.
The following conditions are not covered by this warranty:
1.
Repairs made by anyone other than factory personnel, or an authorized Headhunter representative.
2.
Use of the product to perform duties other than those for which the product was intended.
3.
Physically damaged or altered products.
4.
Pump failure due to foreign debris.
5.
Products with missing or modified labels.
Headhunter will not be responsible for freight damage incurred during shipping to a service center.