User Manual
Page 16 of 16
1.
Connect up to 8 sources such as a Blu-Ray Player, game console, A/V
Receiver, Cable or Satellite Receiver, etc. to the HDMI inputs on the unit.
Do not hotplug! Insert and extract cables carefully with the power
SWITCHED OFF. Connecting and disconnecting while the unit is powered
can result in damage to circuitry.
2.
Connect the output UTP ports and/or HDMI output ports, starting with
output 1, to the E50IR Receiver display receivers (sold separately) (using
well terminated or pre-terminated Cat5e/6 cables no longer than 160 ft).
3.
If utilizing UTP, connect the output HDMI ports of the E50IR Receiver
display receivers (sold separately) to high-definition displays such as an
HDTV or HD projector that use HDMI inputs. Note that high-speed HDMI
cables are recommended for the distances that are required for each
connection.
4.
Plug in IR transmitters to the back of the Matrix Selector Switcher unit
(IR TX), the transmitters are labeled IR TX, place in front of the IR receiver
of the source, ensure that each emitter is placed in front of the IR receiver
eye. Double-sided adhesive tape provided.
5.
Plug in IR receivers to the port of the E50IR Receiver display receivers
(sold separately) ,the receivers are labeled IR RX, use provided double-
sided adhesive tape to stick emitters at each display at a desired place that
will receive a remote signal.
6.
For power, plug in the source first, followed by the Matrix Selector
Switcher (power supply included), followed by the display receivers,
followed by each output connected.
7.
Power on each device in the same sequence.
At this point each display connected should display the assigned source
(input 1 at default when powered on initially), scroll through each of the
sources on each display to ensure everything is in working order. Use
included IR remote at each display receiver to test switching function
between sources and IR function itself. If a display is having difficulty
receiving a signal, access the display's menu and adjust the resolution
(lowest to highest until signal is displayed). A 24 Hz vertical refresh rate
may work better than 60 Hz or higher. If the IR remote function is not
responding, check the emitters to ensure they are placed correctly and are
plugged into the correct IR jacks on the Matrix Selector Switcher unit.
