HCI RoomMate RM20II, Руководство по эксплуатации

Страница: 43 / 68

--------------------------------------------------------------------------------------GEN II OPERATIONS MANUAL
HealthCare Information, LLC 43
USING IPTV
SETTING IP ADDRESSES
If you are not connecting the set to a network you do not need to set the IP address. Skip to IPTV operation on page 44.
If you are connecting to a network then each TV will have to be assigned a unique IP address. In addition you will need
to know the IP address of the media server or MediaCare server and the IP address of the ThinClient server if used. A
ThinClient server will allow a Remote Desktop Session to access PC application such as Internet Explorer.
You will need an HCI IR remote control to set the IP address. After selections are made you must press the “ENTER”
for the change to be accepted. IP address are entered using the number buttons. You will not see the IP address change
until you exit the setup menu and IPTV reboots. To check your settings enter setup again after the IPTV has rebooted.
1. Turn set on and press the IPTV button on an HCI IR remote.
2. Enter setup by pressing the “FUNCTION” button then the “0” button on the IR remote.
3. When “CODE” appears on the upper right corner of the screen enter “9999”. Do not press setup. If setup is
pressed, press the “ENTER” button to remove the TV setup menu from the screen. The IPTV setup menu will
appear.
4. Press the right arrow button
5. IP MODE should be set to Manual. Change to manual if it is not.
6. Arrow down to IP Address, press the “ENTER” button and enter the assigned IP address for this set. Press the
“ENTER” button when finished.
7. Press the down arrow button to select Subnet Mask.
8. Press the “ENTER” button and enter the Subnet Mask. Normal setting is 255.255.255.0. Press the “ENTER”
button when finished.
9. Press the down arrow button to select Gateway Address.
10. Press the “ENTER” button and enter the Gateway Address. This is the IP address of your IPTV file server or
MediaCare server and NOT the ThinClient server.
11. Press the “ENTER” button.
12. Press the left arrow button and then the down arrow button twice to select Thinclient Settings.
Note: If you are not using a ThinClient server skip to IPTV operation on page 44.
13. Press the right arrow button then the down arrow button to select Server Address.
14. Press the “ENTER” button.
15. Enter the IP address of the Thin Client Server. When finished, press the “ENTER” button.
16. Press the “BACK” button. The IPTV will reset. This will take about 30 seconds. When the IPTV has
rebooted you will see the IPTV home screen. You can re-enter IPTV setup to check your settings.