HCI RoomMate RM20II, Руководство по эксплуатации

Страница: 35 / 68

--------------------------------------------------------------------------------------GEN II OPERATIONS MANUAL
HealthCare Information, LLC 35
PILLOW SPEAKER OPERATION
The pillow speaker type should be set before a pillow speaker is plugged into the set. See page 26.
For pillow speakers with an analog (rotary) type volume control, you may wish to lock the TV volume at a preset level to assure
proper volume to the pillow speaker at all times. Some digital pillow speakers have rotary volume controls. See pages 23 and
24.
See page 22 to disable the TV’s internal speakers.
One Button
1. Press the “TV” button on the pillow speaker to turn the set on.
2. Press and release the “TV” button to change the channel to the next programmed channel.
3. To change the direction of the channel change, press and hold the “TV” button until “CHANNEL UP” or
“CHANNEL DOWN” appears on the upper right corner of the screen. About 3 seconds.
4. To turn TV off, press and hold the “TV” button until “POWER OFF” appears on the upper right corner of the
display. About 5 seconds.
3 Button
1. Press the TV button to turn the set on or off.
2. Press the “UP” button to change the channel to the next higher programmed channel.
3. Press the “DOWN” button to change to the next lower programmed channel.
Digital
Any digital pillow speaker that sends Zenith, Philips or RCA (Ver. 1 pillow speaker board only) code may be used with the
ROOMMATE series sets. Make sure the TV is setup for the proper pillow speaker being used before connecting the pillow
speaker. See page 26.
NOTE: Version 2 pillow speaker boards and the optional dual pillow speaker board do not support RCA digital codes. See
pages 11-13 to identify which pillow speaker board is installed in the set.
Pin Out
VIEWED FROM REAR JACK PANEL