HBM TJ1-S6, Руководство по установке, Страница: 4 / 32

HBM: Business Document
Model: TJ1-S6
FCC ID: 2ADAT-TJ1S6
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Fig. 1.2 Example of the label
Appropriate use
The torque transducer is used exclusively for torque, angle of rotation and
power measurement tasks within the load limits stipulated in the specifica-
tions. Any other use is not the designated use.
Stator operation is only permitted when the rotor and stator antenna are
coupled.
The torque flange may only be installed by qualified personnel in compliance
with the specifications and with the safety requirements and regulations of
these mounting instructions. It is also essential to observe the applicable legal
and safety regulations for the application concerned. The same applies to the
use of accessories.
The torque flange is not intended for use as a safety component. Please also
refer to the section: “Additional safety precautions". Proper and safe operation
requires proper transportation, correct storage, siting and mounting, and care-
ful operation.
Loading capacity limits
The data in the technical data sheets must be complied with when using the
torque flange. In particular, the respective maximum loads specified must
never
be exceeded. The values stated in the specifications‐must not be
exceeded, for example, for
•
limit torque,
•
longitudinal limit force, lateral limit force or limit bending moment,
•
torque oscillation width,
•
breaking torque,
•
temperature limits,
•
the limits of the electrical loading capacity.