HBM PW15PH Series, Инструкция по монтажу

Страница: 14 / 64

Electrical connection
12
A03392_02_Y00_00 HBM: public
PW15PH
5 Electrical connection
The following can be connected for measurement signal conditioning:
S
Carrier-frequency amplifiers
S
DC voltage amplifiers
that are designed for strain gage measurement systems.
The load cells are supplied in the standard version with an 8-pin connector in a
six-wire configuration. The load cells are optionally available with different
cable lengths and with a hygienic design connection cable.
5.1 Connection in a six-wire configuration
Plug-in contact 1 = measurement signal (+)
Plug-in contact 6 = excitation voltage (-)
Plug-in contact 5 = sense lead (-)
Plug-in contact 7 = excitation voltage (+)
Plug-in contact 3 = sense lead (+)
Plug-in contact 8 = measurement signal (-)
2
3
4
5
6
7
1
8
Plug-in contact 2 = not in use
Plug-in contact 4 = not in use
Fig. 5.1 Connector pin assignment
With this connector pin assignment, the output voltage at the amplifier is
positive when the transducer is under load (
see Fig. 4.1 ). You can find the pin
assignment for cables available as accessories in Section 9 on page 18 .