Hazet 4650-5, Руководство по эксплуатации

Страница: 5 / 11

The battery-tester 4650-5 indicates the status of a battery in a very short time. This
equipment enables the battery to be tested with and without load. An additional test is the
check of the charging system.
Measurement instrument
The scale shows a 6 Volt and a 12 Volt measurement area. The 6 Volt and the 12
Volt measurement areas are divided in the green, yellow and red areas. For an exact
reading the unit itself must be in a horizontal position. (Measurement instrument with
indicator)
Battery-Voltage Test
<
Connect the unit-clamp with battery. Voltage of the battery will be displayed.
<
Load-Switch in position „OFF“.
< If the indicator should be in the yellow or red area, the battery will be
defective or discharged.
< Check Battery Acid Density with HAZET refractometer
4810C . If necessary charge the battery and repeat the
test procedure.
Battery-Voltage Test
< Connect the unit-clamps with battery. Voltage of the battery will be displayed.
< Load-Switch in position „ON“ for 10 seconds. With this operation the built-in
resistance will produce a load of ~ 100 Amps. This load is similar to the power
consumption of a middle-class vehicle with an average equip. (~1.200 W)
Safety-Information:
During the load test the temperature of the unit will increase.
Do not press the load switch longer than 10 seconds.
After a load test please allow the unit to cool down at least 5
minutes.
GB