HAZET-WERK 9033M-11, Руководство по эксплуатации

Страница: 14 / 28

14
•
Do not use the tool in environments
susceptible to explosions. Tools such as
sanders can cause sparks or ignite combu-
stible materials. Never operate tools in pro-
ximity to combustible substances like petrol,
naphtha, detergents etc. Work in clean,
well-ventilated areas only. Keep combusti-
ble materials out of the work area. Never
use oxygen, carbon dioxide or other bottled
gases to power pneumatic tools.
• Do not point the tool at another person.
Keep children and other persons out of the
work area when operating the tool.
• Do not operate the tool in an idle state.
• Do not allow pneumatic tools to come
into contact with sources of electricity.
• Pay attention to the working pressure.
For max. air pressure see table on page
15 . Exceeding the approved maximum pres-
sure of tools and accessories can cause
explosions and may result in severe injuries.
The maximum pressure of the compressed
air must be equal or inferior to the approved
pressure load indicated for the tool.
• Check the air hose connections are fit-
ted tightly. Do not use defective or worn
pressure hoses. Pressure hoses moving
uncontrollably may cause severe injuries.
•
Only disconnect pneumatic tools in an
unpressurized state. Pressure hoses
moving uncontrollably may cause severe
injuries.
•
Only use clean and dry air.
Never use oxy-
gen, carbon dioxide or other bottled gases
to power pneumatic tools.
• Only use spare parts, attachments and
accessories recommended by the manu-
facturer.
• Never carry the tool by the compressed
air hose.
• Never carry the connected tool with a
finger on the operating lever.
• Avoid unintentional activation.
•
Always keep the handles dry, clean and
free of grease or oil.
• Ensure that the working area is clean,
well ventilated and always well lit.
• Never use the tool whilst under the influ-
ence of alcohol or drugs.
• Repair work must be carried out exclu-
sively by authorized persons.
• Labels on the tool must always be kept
legible. The user is responsible for ensur-
ing that the stickers stating warning
signs, rotational speeds, serial no. and
article no. are not damaged and are easy
to read.
• Do not use quick-release couplings
directly on the tool. There must be a
pressure hose of at least 20 cm length
between the tool and the quick-release
coupling.
• Only replace grinding discs when the air
hose is disconnected.
• Always disconnect the tool from the com-
pressed air supply when replacing the
grinding pads and observe the safety
instructions.
• Only use the grinding pads intended for
use with the tool.
2
For Your Safety
Wear hearing protection!