USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
8
Shaft Seal Change Instructions
CAUTION
-Only qualified personnel should attempt rotary seal replacement. Contact your local authorized
Hayward Dealer or service center if you have any questions.
WARNING
-
Read and follow all instructions
. Failure to follow instructions can cause severe injury
and/or death.
WARNING
–
Risk of Electric Shock
Failure to turn off power can cause serious or fatal electrical shock hazard.
Disconnect all electrical power service to pump before beginning shaft seal replacement.
Exercise extreme care in handling both the rotating and the stationary sections of the two-part replacement seal. Foreign
matter or improper handling will easily scratch the graphite and ceramic sealing surfaces.
1.
Shut off water flow to pump by closing appropriate valves or by plugging both the skimmer outlet port and return
port to pool. Disconnect piping or hoses from the motor/pump assembly.
2.
Remove the strainer by disengaging and removing the strainer cover. Remove the basket. Lift up on strainer ‘C’ clip
and remove. Finally, slide strainer housing forward and remove.
3.
Unscrew eight (8) screws and remove pump cover, exposing the impeller.
4.
Remove the canopy or the shaft cover plate from the end of motor opposite the impeller.
5.
Hold the motor shaft securely by either inserting a screwdriver in slot at end of shaft or by using an open-end wrench
to engage the flat surfaces provided near end of motor shaft. Rotate the impeller in a counterclockwise direction and
remove it from the motor shaft.
6.
Note how the steel spring section of the old seal is positioned on impeller hub and remove it by pulling from the
impeller.
7.
Loosen four (4) motor through bolts from the back of motor and remove pump housing/shroud from the front of the
motor.
8.
Remove the ceramic stationary portion of the old seal by pressing the white ceramic seat out of the pump housing
recess. If assembly is tight, tap lightly from the “motor” side.
9.
Clean and lubricate the impeller stem and the pump housing recess with a dilute solution of non-granulated liquid-
type soap. Do not use petroleum or silicone lubricants as these can contribute to seal leakage.
10.
Press the new rotating portion of the seal assembly onto the impeller stem with the polished black graphite surface
facing away from the impeller.
11.
Carefully press the stationary ceramic portion of the seal into the recess of the pump housing/shroud, with the
polished flat surface facing out.
12.
Carefully insert the motor shaft through the pump housing/shroud and align with white ceramic stationary seal
assembly in place and secure the motor to pump housing/shroud with four (4) motor through bolts removed in step
#7. Be sure motor base and pump discharge port are positioned properly. Alternately tighten the motor through
bolts until the pump housing is secure. Make certain motor shaft turns freely before proceeding.
13.
Screw the impeller (clockwise) with the rotating portion of seal in place onto the motor shaft. Hand-tighten the
impeller in place.
14.
Clean (replace if necessary) the O-ring and replace on pump cover. Assemble the pump cover to the pump housing/
shroud with the eight (8) screws removed in step #3. Tighten screws alternately and evenly.
15.
Re-assemble strainer by sliding strainer housing onto pump cover. Install strainer ‘C’ clip by pushing clip down onto
grooved pump cover coupling. Insert basket and fasten strainer cover.
16.
Reconnect pump to the piping or hoses provided. Open all valves and make sure that the pump strainer housing is
full of water before restarting the pump.
