Installation
– Electrical/High Voltage
High Voltage Wiring terminals (L1 & L2)
1. Voltage: 230 VAC, 60Hz, Single Phase.
2. Breaker, wire size would be determined
by the NEC and local code requirements.
Ground Wire
Terminal.
It is below high
voltage wires
and should be
connected first.
Conduit
Connections
There are two on
the pump. One
for high voltage
and the other for
the low voltage
data cable.
Make sure the unit is both bonded and grounded!
Figure 6
Page 5
Note: When connecting high
voltage for an EcoStar that is
data connected to a Hayward/
Goldline control, voltage
needs to come directly from a
breaker in the control, or in
the case of an OnCommand,
directly from the main or sub-
panel and not from the filter
pump relay.
Bonding Lug
