Hayward AquaRite +, Руководство пользователя

Страница: 39 / 88

USE ONLY GENUINE REPLACEMENT PARTS
Page 17 of 21 Aq Rev. B
7
Intelligent*: In this mode, the user has two operating
parameters: Select the required water temperature
and the minimum filtration time (minimum two hours
and maximum 24 hours). The filtration will operate
for at least ten minutes every two hours to check the
temperature. The minimum filtration time selected is
divided into twelve sections that are added to its ten
minutes.
Example 1: Over twelve hours, the time
is divided between the twelve times a day when the
filtration starts up to check the temperature.
Example 2: (12 hours x 60 minutes) / 12 = 60 minutes
every two hours. This is the filtration and heating
period every two hours. If the programmed filtration
period ends and the required temperature has not
been reached, the filtration and heating remain on until
the required temperature is reached. To minimize the
number of hours during which filtration operates each
day, this additional time will be deducted from the next
filtration periods occurring during the rest of the day.
(See the chart below).
* Note: Modes visible only when the temperature
and / or heating probe use option is activated in the
INSTALLER menu
0h
10 min
1h 3h 5h 7h 9h 11h 13h 15h 17h 19h 21h 23h
2h 4h 6h 8h 10h 12h 14h 16h 18h 20h 22h 24h
T°= 28ºC
0h
10 min
1h
OFF
ON
3h 5h 7h 9h 11h 13h 15h 17h 19h 21h 23h
2h 4h 6h 8h 10h 12h 14h 16h 18h 20h 22h 24h
28ºC 28ºC
27ºC 27ºC
28ºC
Intelligent mode operation if the temperature is constant
Intelligent mode operation if the temperature varies
Intelligent mode
Lighting
1 2 3
OK
+
-
1 Lighting.
2 Manual mode (ON/OFF) .
3
Automatic mode: Starts up according to the time slots used
to set the lighting start and end times. The time slots can
be configured with the following frequencies: daily, every 2
days, every 3 days, every 4 days, every 5 days, weekly, every
2 weeks, every 3 weeks, every 4 weeks.
Setting the pump type
1 2 3 4 5 6
OK OK OK
3 Enter the Service menu from the configuration
menu
4 Enter the password (contact Hayward's technical
support for the code)
5 Enter the Pump type menu.
6 Select the type of pump.