5. Reinstall all 4 of the original screws.
a. Loosely tighten all four screws.
b. Then go back and firmly tighten each screw.
6. The spaside remote will remember the ID code of the base station, so it is not necessary to
perform the “Teach Wireless” procedure again. Verify proper operation by pressing any button
and observing 2 flashes indicating that the message was transmitted to the base station and
a confirmation was received.
Troubleshooting
1. Can’t find the “Teach Wireless” display:
Press the “menu” button (possibly more than
once) until “Settings Menu” is displayed. Next, press the “<“ or “>” buttons (possibly more
than once) unit the “Teach Wireless” display appears. If you get to the point where “Settings
Menu” appears again, then this means that the Pro Logic/Aqua Logic control unit is not
communicating with the base station. Check that the 4 wire cable from the base station is
plugged into the “wireless" connector on the main printed circuit board. If this connector is
already plugged in (for more than 30 seconds), then call Hayward Technical Service for as-
sistance.
2. “Teach Wireless” failed:
Ensure that the remote is powered when pressing the button. This
is indicated by a single flash of the LED on the spaside remote or a message on the display
of the in-house remotes. If the remote is powered, then the next most likely cause is that the
distance between the base station and the remote is too great—try moving the remote closer
to the base station. Lastly, there may be other equipment in the neighborhood that is using
the same frequency. To see if this is the case, go to the Settings Menu/Wireless Channel and
select another channel. Note that after you change the channel you will have to “reteach”
every wireless remote device in the system.
3. Unreliable communication with remote devices:
The most likely cause is that the dis-
tance between the base station and the remote is too great—try moving the remote closer
to the base station. Lastly, there may be other equipment in the neighborhood that is using
the same frequency. To see if this is the case, go to the Settings Menu/Wireless Channel and
select another channel. Note that after you change the channel you will have to “reteach”
every wireless remote device in the system.
4. Single LED flash when a button is pushed:
The radio signal may be too weak—try point-
ing the spaside remote in the direction of the pool equipment or try moving closer to the pool
equipment. If that doesn’t work, then try the “Teach Wireless” procedure to ensure that the
remote knows the ID code of the base station and also what channel to communicate on. If
this procedure is not successful, then refer to the “Teach Wireless” failed section above.
5. The filter pump won’t turn off when the "OFF" button is pressed:
(1) If the heater
cooldown feature is enabled and the heater is on, then pressing the "OFF" button will cause
the heater to turn off but leave the filter pump running for 5 more minutes to allow the heater
to cooldown. Pressing the "OFF" button a 2nd time will override the cooldown period and turn
the pump off. (2) If the freeze protection feature is enabled and the air temperature is less
than 38°F then the pump will run continuously and any OFF button press will be disregarded.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
4
