4. Apply labels:
The Pro Logic and Aqua Logic controls allow each output (e.g. AUX1) to be
renamed to what is actually being controlled. The spaside remote comes with a sheet of name
labels—simply peel the appropriate label off the sheet and apply to the appropriate set of
buttons on the spaside remote.
5. Installation is complete:
You can now use the spaside wireless remote.
Operation
The spaside remote communicates with the base station on the Pro Logic/Aqua Logic control unit
using RF (radio frequency) technology. When you push a button on the spaside remote, it sends
a command and flashes the LED indicator once. After a brief delay, the spaside remote receives
a confirmation from the Pro Logic/Aqua Logic base station and the LED indicator on the spaside
remote will flash 2 times. This double LED flash is your confirmation that the command has been
successfully transmitted to the control unit. If the LED doesn’t flash at all or else just flashes once
after you’ve pushed a button, refer to the Troubleshooting section for assistance in resolving these
problems.
Valves POOL/SPA These buttons will allow you to select either pool or spa operation. You can
not select spa spillover operation from the spaside remote.
Filter ON/OFF
The ON/OFF buttons allow manual operation that will override any automatic
control settings (e.g. timeclock). The manual setting will remain active until
the next scheduled automatic turn on/off event. There are some exceptions:
If the Heater1 is operating and the heater cooldown function is enabled, then
pressing the OFF button will turn off the heater and the pump will run for
another 5 minutes to allow the heater to cooldown before automatically turn-
ing off.
OFF
OFF
OFF
OFF
OFF
SPA
ON
ON
ON
ON
ON
POOL
G
1-
08
03
15
A
-1
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2
