Compatibility
This product is compatible with all Pro Logic controls and Aqua Logic controls operating with soft-
ware revision r1.10 or higher and using an AQL2-BASE-RF Base Station operating with software
revision r3.00 or higher. Note that this product will NOT communicate with an AQL-BASE-RF Base
Station. To verify the software level of your Aqua Logic control, press the Menu button (possibly
multiple times) until "Diagnostic Menu" is displayed. Press the ">" or "<" keys (possibly multiple
times) until the main software revision level is displayed (the revision should be 1.10 or higher).
Next, press the ">" key (possibly multiple times) until the "RF Base" revision level is shown (the
revision should be 3.00 or higher).
If the software revision level is less than those specified above, contact the Technical Service Dept.
from Monday through Friday, 8AM to 8PM Eastern at 908-355-7995 for information on upgrades.
Installation
1. Batteries are installed at the factory:
There is no need to open the spaside unit.
2. Base Station required:
The Pro Logic or Aqua Logic control unit must have an AQL2-BASE
RF base station installed. The base station allows the Pro Logic/Aqua Logic control unit to
communicate with the spaside remote.
3. Teach the unique ID code:
The base station attached to the Pro Logic/Aqua Logic control
unit has a unique ID code that ensures that your unit will not affect other systems in the
neighborhood, and likewise, their remote will not affect your system. To teach the ID code to
the spaside remote unit:
a. On any Pro Logic/Aqua Logic display/keypad unit press the
“Menu” button (possibly multiple times) until “Settings Menu” is
displayed.
b. Press “<“ or “>” (again, possibly multiple times) until “Teach Wire-
less” is displayed.
c. Press the “+” button to start the teaching process.
d. Press and hold any button on the spaside remote. The LED indica-
tor should blink once when the button is first pushed. Continue
holding the button until the LED flashes 3 times (within about 7
seconds). This is a confirmation that the operation was successful.
The Pro Logic/Aqua Logic display will indicate “Teach Wireless:
Successful” at this time. If the LED indicator does not flash 3 times,
refer to the Troubleshooting section of this manual for additional
information.
Settings
Menu
Teach Wireless:
+ to start
Teach Wireless:
Successful
Press and hold
wireless button
1
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
