USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2
SS-D-BOX) are available for both remotes to aid in installation. For mud box installation, refer to
the instructions included with the boxes. For all other installations, refer to the information on the
following pages.
Surface Mount Installation (without Mud Box)
1. The AQL-SS-6B/D’s unique design allows you to use 1½”, 1¼”, or 1” diameter Schedule 40
PVC for installation. Install a 6” (minimum) piece of PVC pipe in the pool/spa wall at a loca-
tion above the high water mark. There must be at least 2” of clearance from coping stones
or other raised objects to the Schedule 40 pipe. It is advisable that this pipe be plumbed as
level as possible although the O-ring is designed to compensate for small variations from
perpendicular if necessary.
2. The pipe should protrude beyond the finished surface of the spa, as it will be cut back after
surface finishing is completed. Reduce the pipe to ½” or ¾” electrical conduit and run back
to the Pro Logic/Aqua Logic, using sweep elbows for any turns in the run.
3. Depending on the PVC pipe size used, mount the appropriate size O-ring on the back of the
remote control as shown below and cut the other two off of the cable.
4. When the spa construction is completed, cut back the PVC conduit receptacle flush with the
spa wall or surface of the deck. Run the cable from the AQL-SS-6B/D through the conduit to
the Pro Logic or Aqua Logic.
5. Run a small bead of silicone sealant along outside edge of the remote control. Attach remote
to the mounting surface by sliding the O-ring into pipe and pushing against the surface.
NOTE: Do NOT apply sealant to compression O-ring or PVC pipe. See below.
1”, 1¼”, 1½” Compression
O-Ring
1 in. PVC
Conduit
1½ in. PVC
Conduit
Remote
1” Compression
O-Ring
1½” Compression
O-Ring
cable
cable
Apply Silcone Sealant
along outside edge only
Apply Silcone Sealant
along outside edge only
