Haybuster H-1135, Руководство по эксплуатации

Страница: 43 / 176

33 H - 1 1 3 5 T U B G R I N D E R O P E R A T I N G I N S T R U C T I O N S
2.3.4 How to operate machine as a unit
INTRODUCTION
Tractor engines are designed to reach maximum power at PTO speed (1000 rpm), and most tractors are capable of
engine speeds from 10 to 20 percent over PTO speed. It will be necessary to operate tractor PTO at approximately
1000 rpm.
The Electronic Governor controls the feed rate to keep the tractor at its peak power point. The operator is able to select
the operating range so that when the feed of material lugs down the tractor, the Electronic Governor will reduce the feed
at a high enough PTO speed for the tractor to recover automatically if a slug is encountered.
GRINDING
Place materials to be ground directly into the tub. The best method for filling the H-1135 Tub Grinder is:
1. Engage Rotor and increase speed to 1000 RPM on the PTO shaft
2. Fill the tub about half full of unground materials before starting tub rotation.
3. Start tub.
4. Place additional materials in the tub.
LOOSE HAY
The best capacity will be obtained if the tub is consistently kept no less than half full of loose hay. When loading the
tub, place materials slightly to the front rather than directly over the rotor. For best results feed the tub with small
portions.
WET OR FROZEN HAY
This is the toughest material for any grinder to handle. When filling the tub with wet or frozen hay, deposit small
quantities on a more frequent basis rather than filling the tub with one load.
LARGE ROUND BALES
Place large round bales in the tub on end or on the side. Try grinding bales each way to determine which method will
work best for you.
IMPORTANT: Never drop a large round bale into the tub from a high level. Ease the bale over the
edge and down into the tub carefully. Dropping a large bale directly on top of the rotor will cause
damage to the rotor.