Haybuster H-1135, Руководство по эксплуатации

Страница: 73 / 176

63 H - 1 1 3 5 T U B G R I N D E R O P E R A T I N G I N S T R U C T I O N S
MOUNTING
Install the non expansion unit first.
1. Apply a coating of light oil or other rust inhibitor to
the adapter area of the shaft.
2. Before mounting bearing to shaft, remove
lockplate from bearing and turn locknut
counterclockwise one to two turns to allow adapter
to expand fully. The unit is now shaft ready. Slide
the bearing to the desire position on the shaft.
3. Proper locking of this unit to the shaft is based on turning the locknut clockwise 1-1/4 to 1-1/2 turns. The
turning of the locknut must start from a “ZERO reference point.” This “ZERO reference point’ is defined
as the point when the clearance between adapter sleeve, shaft and bearing bore has been removed, and all
surfaces are in metal to metal contact
3A. To reach the ‘ZERO Reference Point,” rotate locknut clockwise, using both hands, as tight as possible.
Continue to tighten 1-1/4 to 1-1/2 turns.
NOTE: All Weight Must Be Removed From The Bearing When Obtaining The
“ZERO Reference Point.”
Picture 1