Haybuster H-1135, Руководство по эксплуатации

Страница: 41 / 176

31 H - 1 1 3 5 T U B G R I N D E R O P E R A T I N G I N S T R U C T I O N S
2.3 Machine Operation
2.3.1 Tractor Set Up
A tractor drawbar and 3-point arms can cause interference with the PTO driveline. This interference can cause serious
damage to the PTO guarding and the PTO telescoping members.
If this implement is attached to a tractor with a clevis hitch (hammer strap) style drawbar, the hammer-strap must be
removed to prevent damage to the PTO guarding and the PTO telescoping members. See Figure 2.2.
If this implement is attached to a tractor with an offset in the drawbar, be certain it is in the down position to prevent
damage to the IID guarding and the IID telescoping members. See Figure 2.3.
If this implement is attached to a tractor with 3-point arms,
the arms must be fully raised and locked in position to
prevent damage to the PTO guarding and the telescoping
members. Adjust the tractor drawbar so the distance from
the end of the PTO shaft on the tractor to the center of the
drawbar hitch pin hole is 16” (41 cm.) for a 1-3/8” shaft, or
20” (51 cm.) for a 1-3/4” shaft, as shown in the illustration
to the right.
Figure 2.2
incorrect clevis hitch
(hammer strap) style
drawbar set up
Figure 2.3
incorrect offset style
drawbar set up