w w w . h a w k e y e e l e c t r o n i c s . c o m
3. Press the "UP” key to increase the Keel Offset value. Press the "DOWN" key
to reduce the value.
4. The display will return to the normal operation mode after five seconds if no
keys are pressed.
5. “K/O” will remain illuminated in the top left hand corner indicating that the
depth readings are adjusted to the Keel Offset setting.
N
OTICE
:
Each time the Keel Offset setting is changed you must wait 5 seconds
for the depth finder to return to the Normal Operation Mode in order for
the setting to be saved?
UNITS OF MEASURE
The units of measure for the depth readout and alarm functions can be set in 4
easy steps. The two settings available are Feet (FT) and Meters (M). You must
be in the “Depth Sounder” mode to adjust this setting.
To Set the Units of Measure:
1. Press and hold the "UP" and “DOWN” keys
until the current unit of measure begins to blink
(approximately 8 seconds)
.
•
On depth finders with Temperature
press and hold BOTH the “UP” &
“DOWN” keys until
FT or M
blinks on
the display”
2. Release the Keys.
3. To set the units to FEET press the “UP” key.
“FT” will flash on the Display.
4. To set the units to METERS press the “DOWN” key. “M” will flash on the
Display.
5. The display will return to the normal operation mode automatically after five
seconds.
N
OTICE
:
Each time the Units of Measure is changed you must wait 5 seconds for
the depth finder to return to the Normal Operation Mode in order for the
setting to be saved?
