Connecting the Starter Disable Feature:
The wire harness containing the starter wire may be located on either side of the
steering column.
Using a Digital Multi meter probe the wire you suspect to be the starter wire.
This wire will have a +12VDC present only when the ignition switch is in the
(START/CRANK) position.
Cut the starter wire in a location that allows easy access to both ends for
1.
stripping and adding a crimp connector. Strip each end with wire strippers.
Place the key in the ignition switch and rotate to the start position. If the
2.
correct wire has been cut the motor will not crank. Use a digital multi meter to
determine which of the two stripped wires has a +12VDC present in the START/
CRANK position (normally the wire that leads to the ignition switch)
See below for example of immobiliser installation diagrams:
2 x Green Immobiliser Circuit (see above)
1.
Connect White wire of Immobiliser socket to Green wire of 4 pin connector of
2.
GPS System
Connect Yellow wire of Immobiliser socket to Negative (-) Permanent
3.
8
