Hawaiian shaved ice S-900A, Инструкция по эксплуатации

Страница: 12 / 18

Assembly and use:
1. Always ensure that the appliance is switched off, and that it is
not plugged into an electrical outlet before you assemble and
dismantle the ice shaver.
2. Fill the ice molds (Figure A. 5) with water. Place the ice molds
on a level surface in the freezer until the water is completely
frozen. Once frozen you will have a small round block of ice. If
needed, additional ice molds may be purchased. See page 17 of
this instruction manual for ordering details.
3. Standard household ice cubes that are produced from most
residential refrigerators may be used instead of ice blocks
however the shaved ice produced from ice cubes will not be as
fluffy as shaved ice produced from ice blocks.
4. To assemble the ice shaver, place the support base (Figure A. 1)
on your work surface.
5. Insert the ice crusher cup (Figure A. 2) into the support base
(Figure A. 1) ensuring that the ice crusher cup is completely
inserted into the support base (Figure A. 1).
6. Position the non-slip mat on the support base (Figure A. 6).
7. Place a small bowl (not supplied) or ice cup (not supplied) on the
support base (Figure A. 1) and under the ice crusher cup (Figure
A. 2). The small bowl or ice cup will be used to catch the shaved
ice produced by the ice shaver.
8. Take the frozen ice molds out of the freezer. Remove the frozen
round ice block from the plastic ice mold.
12