KK-XXX-06_INST_8-07
15
An awe or scribe will help
align the holes
THE FOLLOWING STEPS ARE EXTREMLY CRITICAL FOR A SUCCESFULL
INSTALLATION! PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY.
Item #1
Rear driver-side
doorframe wing
Position of driver-side
Rear
Doorframe
when insta ling with
factory rear air
There should be at
least ¼” of space between the
A/C blower motor and wing
l
8”inches
Lower Driver-Side rear
Measurement from driver-side
Rear Doorframe
to vehicle
e shown above
doorfram
8” inches
Lower Passenger-Side rear
Measurement from passenger-side
Rear Doorframe
to vehicle
doorframe shown above
Cut door gasket with utility kni
of door acceptor fram
fe. Cut gasket to the length
e. Attach as shown above.
Position the entire unit according to the
measurements on the following page.
Note: Maneuver the kit into position.
Tighten screws holding
Rear
Doorframe
to
Center Divider
Item #6
to
Item #7, #8, #12
to
#5
Continue around the entire kit bolting
all
Ceiling
pieces to
Bulkheads
and
Doorframes
using ¼ x ¾” carriage
bolts, washers, and serrated nuts
#3, & #6
¼”
Pry bar
