Haverland AIRPURE 19, Инструкция по эксплуатации

Страница: 31 / 85

13
Healthy air protect lock.
If you do not replace the filter in time, the appliance stops operating in
approx. 2 weeks after the filter replacement light started flashing. When the
appliance is locked, it does not operate until you have replaced the new
filter and pressed the reset button.
Note: When filter replacement light 2 and REPLACE FILTER on the control
panel are on constantly, the appliance is locked ( see section "Filter
maintenance" in this chapter for more information).
How long it takes before the appliance is locked depend on the operating
time and speed level selected after the filter replacement alert.
Approximately 1 day before the appliance locks, the appliance will beep
every 30 minutes to inform you that one of the filters needs to be replaced .
You can switch off the appliance by pressing the on/off button.
If the appliance is locked:
Check which filter needs to be replaced ( see section "Filter
replacement lights").
Switch off the appliance and unplug it.
Replace the appropriate filter (see section "Replacing the filters")
Replacing the filters
Tip: Place the appliance against a wall for more stability when you
remove or insert the filters.
Switch off the appliance and unplug it.
Place your fingers in the recesses of the side panels and gently pull
the top part of the front panel towards you.Then lift the hooks at
the bottom of the panel out of the bottom of the appliance.
To remove filter 3 ( pre-filter), grab the two tabs and pull the filter
towards you.
To remove filter 2 (Activated Carbon filter) , grab its tag and pull it
towards you.
To remove filter 1 (HEPA filter) , grab its tag and pull it towards you.
Discard the filter that needs to be replaced and unpack the new
filter.