WARNING:
THIS TOOL MUST BE GROUNDED WHILE IN USE IN ORDER TO
PROTECT THE OPERATOR FROM ELECTRIC SHOCK.
!
WARNING:
If any part is missing or damaged, do not plug in the table saw until
you have replaced the missing or damaged parts.
To avoid injury, the styrofoam block should be removed between the motor and
the table.
!
ELECTRICAL INFORMATION
UNPACKING
38
ENGLISH
Use a separate electrical circuit for your tools. This circuit must consist of not less
than #12 wire with a 20 A time-delayed fuse or a #14 wire with a 15 A time-delayed
fuse. Before connecting the motor to the power line, make sure the switch is in the
OFF position and the electric current is rated the same as the current stamped on
the motor nameplate. Running at a lower voltage will damage the motor.
Refer to below illustration.
1. Carefully remove the table saw from the carton.
2. Separate the parts.
3. Lay out all parts, and check them against the parts listed below. Examine
all parts carefully.
A. Table saw parts
B. Stand parts
If any parts are missing or damaged, please contact Customer service at
1-866-206-0888.
Table saw assembly
Push stick
Rip fence
Mitre gauge
Rear table extension
Left table extension
Right table extension
Blde guard
kickback pawls
Hex key
Blade wreches
Stand legs
Long top
leg brackets
Short bottom
leg brackets
Rubber feet
Nuts M6
Nuts M6
Bolts M6 x 45
Flat washers 6
Bolts M6 x 14
Spring washers 6
Long bottom
leg brackets
Short top
leg brackets
