Haussmann 58485004, Руководство оператора

Страница: 20 / 24

19
BASIC SANDING OPERATION
NOTE: This tool is approved for sanding wood and wood
products only.
• Select and install the desired sanding sleeve and drum
for the particular application. Choose the size that is simi-
lar to the contour of your workpiece.
Failure to use the correct size table insert with its match-
ing sanding sleeve could result in fingers being pinched or
the workpiece being pulled down between the table insert
and sanding sleeve.
In general, coarse grit removes the most material and fine
grit produces a better finish.
For best results, start with a coarse grit and sand until the
surface is uniform. Medium grit may then be used to re-
move scratches left by the coarser grit and finer grit used
for finishing of the surface. Always continue sanding with
each grit until surface is uniform.
DUST COLLECTION
Refer to Figure 9.
A dust collection port has been provided; it is located be-
neath the work table on the rear side of the sander.
The use of a dust collection device (vacuum, etc.) is highly
recommended. Sawdust buildup beneath the table may
prevent the spindle from oscillating completely, causing
damage to the tool.
Figure 9 - Location of Dust Port
Dust Port
WARNING
Make certain that the unit is disconnected from
power source before attempting to service or remove any
component.
CLEANING
Keep machine and workshop clean. Do not allow sawdust
to accumulate on the tool. Keep the drums clean.
Be certain motor is kept clean and is frequently vacuumed
free of dust.
Use soap and water to clean painted parts, rubber parts
and plastic guards.
LUBRICATION
The shielded ball bearings in this tool are permanently
lubricated at the factory. They require no further lubrica-
tion.
• Apply a light coat of paste wax to the work table. This
will make it easier to feed the work and also prevent
rust.
• Periodically apply grease to the worm gear (Ref. No. 55).
TOOL REPAIRS
• If power cord is worn, cut, or damaged in any way, have
it replaced immediately.
• Replace worn abrasives when needed.
• Replace any damaged or missing parts. Use parts list to
order parts.
• Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician.
• Call the customer line at 1-866-206-0888.
WARNING
MAINTENANCE