HAUSSLER HM 70, Руководство по эксплуатации

Страница: 15 / 60

Switching on the machine
i
The names of the parts are listed in Tab. 3 on page 10, Tab. 4 on page 13, and Tab.
5 on page 14.
i
Before switching on the machine, turn the adjusting wheel to move the millstone
6
up.
i
If grain is too moist, the millstone may become soiled, leading to the formation of
mould.

Do not mill grain with a residual moisture content of more than 13 - 15%.
 Unlock the “EMERGENCY OFF switch” A by pulling the switch out and turning it
clockwise.
 Next, open the slider for the flour outfeed, sack filling
5
, or the sifting device
10
.

Press the “System ON/OFF” switch
G
to switch on the machine.

Then switch on the sifting device
10
, if there is one. Follow the operating instruc -
tions for the sifting device, if you are using one.
 Press the “Mill ON/OFF” switch
E
.
i
Wait for the machine to reach full speed. The controller disables metering so that
the millstones are not blocked by grain when the motor starts up.

Turn the adjusting wheel
6
slowly towards “Fine” until the millstones just about
make contact.
i
You will hear an audible grinding noise when the stones come into contact.

Tighten the fixing bolts
H
to secure the adjusting wheel
6
.

Turn the “Dosage u/min” switch
C
to the center position.
 Press the “Dosage u/min” switch
C
.
i
Adjust the dosage controller (“Dosage u/min”
E
) to vary the throughput rate.

Set the adjusting wheel
6
to the required milling fineness while the grain is being
fed into the mill.
 Turn the fixing bolts
H
to secure the adjusting wheel
6
.
15
Milling