Hauppauge WinTV-DVB, Инструкция по установке и справочник

Страница: 7 / 62

Introduction
This manual describes the installation and use of the WinTV NEXUS-s and
WinTV-DVB-c . With the WinTV-NEXUS-s you can receive Satellite TV and
Radio stations to your P.C, from your satellite antenna. With the WinTV-DVB-c
you can receive Cable TV and Radio stations on your P.C, if you are located
in a Cable area. Both can also be used with dataservices so welcome to the
world of Digital TV.
Note: This manual cover the installation under the operating systems
Microsoft ® Windows ® 98/Me/2000 and XP. The software needed is located on
the root drive of the CD-ROM. This software cannot be installed under
Microsoft
® Windows ® 95 or NT4.0, because it is based on the WDM (Windows
Driver Model). The software for Windows 95 and Windows NT4.0 is located in
the folder \DVBs123b.
Minimum System Requirements
To use the WinTV-DVB / NEXUS card, you will need the following:
• PC with Pentium Processor, (Pentium 233 or higher recommended)
• Free bus-master PCI Socket (PCI specification 2.1)
• 32MB RAM / 32MB harddisk space (minimum)
• PCI or AGP Graphic card, running at a minimum resolution of 800 x 600
Pixel, in either 'High Colour' (16 Bit) or 'True Colour' (24 or 32 Bit)
• Active speaker or soundcard/speaker combination
• CD-ROM Drive (only required for software installation)
• Microsoft ® Windows ® 98/Me/2000/XP
• DirectX 7 or higher
• Microsoft Internet Explorer 5.5
In addition, you need a connection to a digital ('combo' or 'high-band') satelli-
te system. If this system incorporates a switch box, this switch box needs to
be DiSEqC (Digital Satellite Equipment Control) compatible. The physical
connection on the
WinTV-NEXUS card is a single F-Connector.
Furthermore you need a connection to a satellite reception antenna or to a
satellite reception system which can receive digital satellite signals (DVB
satellite).
1