haupa SMART-LINE SH-6, Инструкция по эксплуатации

Страница: 4 / 8

Operating:
• Select the required pressing die.
• Never use a crimping tool without pressing dies!
• The pressing procedure can be stopped at any time by releasing the actuation switch.
• No components under power may be compressed.
• The tool is not insulated!
• The tool is not designed for permanent use.
• After 35 - 45 compression actions carried out one after another, you must take a break
of 10 to 15 minutes to allow the tool to cool down.
• If it is heated too high, this may cause damages to the tool.
• Do not use under water or when it is raining.
• Please observe the processing notes for the relevant connection materials as detailed in
our catalogue.
4. Removing and inserting the battery
Never short-circuit the battery.
ATTENTION:
Hold the tool firmly and press the battery release button to remove the battery.
Inserting the battery
Insert the battery until it clicks into place. Make sure the poles are facing the right way.
Die holder
Pushbutton for return movement
Pushbutton to advance
Illustration 1