Haulotte HA 41 PX, Инструкция по эксплуатации и техническому обслуживанию

Страница: 55 / 82

Operation and Maintenance
43
Caution !
RECALL : All of these frequencies should be reduced when working in
difficult conditions (consult the After Sales Service if
necessary).
5.3.2 - Operating mode
For all refills and greasing, use only
the lubricants recommended in the
table in chap. 5.2.1, page 40.
NOTE : Recycle the drained oils in order not to pollute the environ-
ment.
5.3.2.1 -Hydraulic oil filters
• Change the cartridge (1) if the red light appears on the indicator (2).
• Unscrew the base (3), remove the cartridge and screw in a new car-
tridge.
• Rearm the chock indicator (2) by pressing this so that it turns back to
green.
NOTE : The jacking check must be done when warm - in cold condi-
tions the indicator may light due to the viscosity of the oil.
Every 500 hours or
every 6 months • Engine: see manufacturer's notice
• Drain the wheel reduction gear. Refill: 4 x 1,4l capacity.
• Check the play between crown wheel and reduction gear teeth (this
should be between 0.3 and 0.6 mm)
• Check the tightness of the crown wheel screws (torque 21.5 mdaN)
• Check the proper calibration of the weighing system in different suspen-
sion positions.
• Carry out a static test of the jacks (rod movement < 3mm / 30 min)
24
25
26
OPTIONAL: Every
500 hours or every 6
months • Drain : hydraulic oil reservoir (if optional biodegradable oil is used) 27
Every 1000 hours or
every year • Engine: see manufacturer's notice
• Drain : hydraulic oil reservoir
• Check the tightness of the fly jib telescopic action chains.
• Using the Optimiser console, in the Failures menu, check that the record
of errors is 100% OK (consult the After Sales Service)
• Check the play in the crown wheel roll path (< 1.6mm
27
36
Photo 14 Hydraulic oil filter equipment circuit Photo 15 Hydraulic oil filter lateral movement circuit
3
2
1
2
1
3