Haulotte HA 41 PX, Инструкция по эксплуатации и техническому обслуживанию

Страница: 36 / 82

Operation and Maintenance
24
Caution !
Caution !
Caution !
Caution !
• Do not draw from a barrel if this has not been decanted and never use
fuel at its bottom.
Because of fire hazard during the filling of the tank, take the following
precautions:
• do not smoke
• turn off the engine if it is on
• stand upwind so as not to be sprinkled with fuel
• touch the outside of the opening of the tank with the spout of the pump
before starting to fill the tank in order to avoid the risk of static electri-
city sparks
• close the stopper of the tank properly and clean off any fuel which may
have run out from the tank.
4.2 - UNLOADING - LOADING - DISPLACEMENT - PRECAUTIONS
NOTE : When starting up a machine which has been slung and trans-
ported, it is possible that the safety system will detect a "false
overload", and prohibit all high level movements. In this case,
raise the suspension platform a few centimetres from the low
position in order to re-initialise the system.
A wrong movement can bring about
the complete breakdown of the
machine and cause very serious
personal and material injuries.
NOTE : Before any handling, check the condition of the machine in or-
der to ensure that it was not damaged during transport. If not,
put in writing, the necessary reservations to the conveyor.
Carry out unloading operations on a stable surface which is sufficiently firm
(chap. 2.4, page 10), flat and unobstructed..
During transportation of the
machine, the turret must be
chocked using the rotation pin stop
located under the turret Photo 3,
page 29.
4.2.1 - Unloading with ramps
Precautions: make sure that the ramps can support the load, that they are
correctly fixed and that there is sufficient grip to avoid any risk of slippage
during the manoeuvre.
Never get under or too close to the
machine during the manoeuvres.
NOTE : As the slope of the ramp is almost always higher than the
maximum slope of work (4°), it is necessary to have the fly jib
and arms lowered to allow the movement. In this case, the
sound-effects function but movement is possible.
If the slope is higher than the maximum slope during movement (voir
chap. 2.4, page 10), use a winch in addition to traction.
This method requires the starting
up of the machine. Refer to
chap. 4.4, page 30 to avoid any risk
of false manoeuvres.
4.2.2 - Loading
The precautions are identical to those for unloading.
Stowing must be ensured in accordance with the sketch below:
• the machine must be in its folded position