Haulotte Group H14T, Инструкция по эксплуатации и техническому обслуживанию, Страница: 62 / 78

Operating and maintenance instructions - H14TX - HA16TPX
48
5.3 - OPERATIONS.
5.3.1 - Summary table.
REMINDER: The frequencies given above are to be reduced in the case of work in difficult
conditions (consult the After-Sales department if necessary).
Frequency Ref. Operation
Every day or before
each start of
operations
1
2
3
4
5
6
7
Check the following levels
• motor oil
• hydraulic oil,
• diesel.
• electric batteries.
Check the cleanliness
• disel pre-filter, replace it if water or impurities are found.
• motor air filter.
• machine (in particular, check the tightness of connections and hoses), use
the opportunity to check the condition of the tyres, cables and all accessories
and equipment.
Check the hydrualic oil filter for clogging.
Change the cartridge if the clogging indicator is visible.
Check the state of wear of the articulation axles.
The first 50 hours 9
10
Change the hydraulic oil filter cartridge (see frequency 250 hours).
Change the oil of the drive wheel reducers (see frequency 500 hours) (2 points for
4x2 model - 4 points for 4x4 model).
Check the tightness of the slew ring screws (torque 8.7 daN.m).
Every 50 hours 11
12
14
15
16
17
18
19
Motor: see manufacturer’s manual.
Check the level of the drive wheel reducers (see section 5.3.2.2).
Grease:
• jib articulation axle (for H16TPX): 2 points.
• basket link part articulation axle: 4 points.
• boom base axle: 1 point.
• wheel pivot pin axles: 8 points.
• steering axle, central pivot pin and clevis pin: 10 points.
• slew ring: bearing 2 points.
Every 250 hours 20
21
23
Motor: see manufacturer’s manual.
Grease the friction parts of the telescope (spatula). At the same time, check the
condition of the friction pads.
Check the tightness of the wheel nuts (torque 32 daN.m).
Change the hydraulic filter cartridge.
Check condition of rings (condition and positioning) and exchange them if
damaged or broken
Check 'wear and tear' indicator of the telescope feet; to be replaced if indicator not
visible
Every 500 hours 24
25
26
Motor: see manufacturer’s manual.
Change the wheel reducer oil. Fill up (capacity 4 x 1.4 litres.for 4*4 and capacity
2 x 1.4 litres for 4*2).
Ring screws check the tightness and tighten if necessary. (torque 8.7 daN.m).
Every 1000 hours
or every year 11
27 Motor: see manufacturer’s manual.
Empty the hydraulic oil tank.
Every 2000 hours 28
29
30 Empty the tank and the whole hydraulic oil circuit.
Empty and clean the diesel tank.
Grease the rotation reducer: 1 point.
Every 3000 hours Check the condition of the telescope friction pads, the electric cables and
hydraulic hoses.