Haulotte Group H14T, Инструкция по эксплуатации и техническому обслуживанию, Страница: 17 / 78

Operation and maintenance
5
1.4 - INSPECTIONS
Comply with the national regulations in force in the country of machine use.
For FRANCE: Order dated 01/03/2004 + circular DRT 2005-04 dated 24
March 2005 which specify:
1.4.1 - Periodic inspections
The machine must be inspected every 6 months in order to detect any
defects liable to cause an accident.
These inspections are performed by an organisation or personnel specially
designated by the site manager and under his responsibility (whether or not
they belong to the company) Articles R 233-5 and R 233-11 of the French
Labour Code.
The results of these inspections are recorded in a safety register kept by
the site manager and constantly available to the labour inspector and the
site safety committee (if one exists) and the list of specially designated
personnel (Article R 233-5 of the French Labour Code).
Moreover, before each use, check the following:
• the operator’s manual is in the storage compartment on the platform,
• the stickers are placed according to the section concerning "Labels
and their positions",
• oil level and any elements in the mainteance operation table
• look out for any danaged, incorrectly installed, modified or missing
parts.
NOTE : This register can be obtained from trade organisations, and in
some cases from the OPPBTP or private prevention agen-
cies.
The designated persons must be experienced in risk prevention (Articles R
233-11 or order n° 93-41).
No member of personnel is allowed to perform any check whatsoever
during machine operation (Article R 233-11 of the French Labour Code).
1.4.2 - Examination of machine suitability
The manager of the site where the machine is operated must ensure the
machine is suitable, i.e. capable of performing the work in complete safety,
and in compliance with the operating manual. Furthermore, the French
order of 01/03/2004 addresses problems relative to leasing, examination of
the state of conservation, checking upon operation after repairs, and test
conditions (static test coefficient 1.25; dynamic test coefficient 1.1). All
users must consult this order’s requirements and comply with them.
1.4.3 - State of conservation
Detect any deterioration liable to cause hazardous situations (concerning
safety devices, load limiters, tilt sensor, cylinder leaks, deformation, welds,
bolt tightness, hoses, electrical connections, tyre state, excessive
mechanical gaps).
NOTA : In the case of rental, the user of the rented device is respon-
sible for the machine condition and suitability inspection. He
must check with the renting party that the general periodic
checks and checks prior to operation have been carried out.