HAUBER-Elektronik GmbH
Shell Half
Arrow and Eye
Sign
Fastened Safety Clip
Protective Cover
Fastened Protective Cover
Safety Clip
Fully insert the connection cable socket into the M12 connector.
(Pay attention to the code cam position!)
16.2
Zone-2-22—Fastening Safety Clip / Protective Cover
1.
Disconnect th control from the mains.
2.
Separate both shell halves of the fuse clip using a screw driver.
3.
Use the M12 connector to firmly close the protective cover.
1.
2.
3.
Tightly fasten the lock-nut of the connection cable socket by hand.
Mount the safety clip to avoid accidental disconnection of the plug connection:
1.
Place both shell halves of the safety clip around the plug connection.
2.
Press both shell halves of the safety clip together by hand until the
catch lock engages.
3.
Place the arrow connected to both shell halves around the cable, then thread
it through the eye on the other end so that the notice sign is legible
alongside the cable.
Fastening Protective Cover
Fastening Safety Clip
Disassemble the safety clip and fasten the protective cover:
Always operate model Zone-2-22 with the safety clip to avoid accidental disconnection of
the plug connection! Otherwise, there is an explosion hazard from sparking when operating
this control in potentially explosive atmospheres!
Fasten the protective cover using the M12 connector after disconnecting the plug connection!
14
汉矢德传感器（上海）有限公司
T
：
150 210 98804 www.hauber-elektronik.cn
