Hatco FLAV-R-SAVOR FSHC-6W1, Инструкция по установке и эксплуатации

Страница: 3 / 20

Hatco corporation is not responsible for the
actual food product serving temperature. It is
the responsibility of the user to assure that
the food product is held and served at a safe
temperature.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-
0607 or 414-671-6350; fax 800-690-2966 or
International fax 414-671-3976.
This product has no “user” serviceable parts.
To avoid damage to the unit or injury to
personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Parts when
service is required.
Genuine Hatco Replacement Parts are
specified to operate safely in the
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment. It
is essential to use Hatco Replacement Parts
when repairing Hatco equipment. Failure to
use Hatco Replacement Parts may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical shock
or burn.
Form No. FSHC67M-0808
1
IMPORTANT SAFETY INFORMATION
WARNINGS
Plug unit into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. If the plug and receptacle do
not match, contact a qualified electrician to
determine the proper voltage and size and
install the proper electrical outlet.
To avoid any injury, turn the power switch
OFF, unplug the unit from the power source
and allow to cool completely before
performing any maintenance or cleaning.
For safe and proper operation, the unit must
be located a minimum of 1" (25 mm) from
combustible walls and materials. If safe
distances are not maintained, discoloration or
combustion could occur.
Overfilling can cause electrical shock. Stop
filling when Low Water light goes off.
To avoid any injury, turn the power OFF to the
unit and allow to cool before draining.
To prevent any injury or damage to the unit do
not pull unit by power cord.
To prevent any injury, discontinue use if
power cord is frayed or worn.
To avoid electrical shock or personal injury,
do not steam clean or use excessive water on
the unit.
Some exterior surfaces on the Holding
Cabinet will get hot. Use caution when
touching these areas to avoid injury.
The unit must be serviced by qualified
personnel only. Service by unqualified
personnel may lead to electric shock or burn.
ELECTRIC SHOCK HAZARD: Turn the power
switch OFF, unplug the power cord, and allow
the unit to cool before performing any
maintenance or cleaning.
IMPORTANT! Read the following important safety information to avoid personal injury or
death, and to avoid damage to the equipment or property.