Hatco FLAV-R-SAVOR FSHC-6W1, Инструкция по установке и эксплуатации

Страница: 14 / 20

Form No. FSHC67M-0808
12
MAINTENANCE
REMOVING LIME & MINERAL
DEPOSITS
NOTICE
Water Quality Requirements - Incoming water in
excess of 3.0 grains of hardness per gallon
(GPG) (.75 grains of hardness per liter) must be
treated and softened before being used. Water
containing over 3.0 GPG (.75 GPL) will decrease
the efficiency and reduce the operating life of
the unit.
NOTE: Product failure caused by liming or sediment
buildup is not covered under warranty.
NOTE: If the water used has an excessive amount
of lime or mineral content, follow the instructions
listed below for periodic cleaning and deliming of the
water reservoir.
1. Turn the power switch off and unplug the unit
from its power source.
2. After the unit has cooled down, drain all
remaining water out of the unit. See DRAINING
THE RESERVOIR .
3. Fill the unit with a mixture of 75% water and 25%
off-the-shelf vinegar, (approximately one gallon).
4. Turn the power switch ON and allow the unit to
heat up to the operating temperature of
170-180°F (77-82°C). Run the unit at this
temperature for 1-2 hours.
5. Allow the unit to stand with the mixture in the
reservoir for a minimum of 4 hours. (Preferably
overnite.)
6. After the deliming period, drain the vinegar and
water from the tank.
7. Continue to fill and drain the unit with water only,
until the discharge is clear and all deliming
solution has been removed and rinsed.
8. Plug the cabinet power cord into its power source
and fill the unit as usual for daily operation.
NOTE: How often this procedure must be performed
depends on the lime and mineral content of the
water used for daily operation.
WARNING
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
WARNING
This product has no “user” serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Parts when service is required.
WARNING
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.