60
User Manual Version 3.1
PAPER SENSOR
Here you can adjust the behaviour of the paper sensor.
Option Note
On
The paper sensor (also Top of Form (TOF) sensor)
detects the front edge and the rear edge of the
material. In this setting the paper sensor is active
over the complete length of the material. The paper
length is controlled in this setting, so paper jams or
double feeds will be detected.
Off
The paper sensor detects the front edge of the
material. Then the paper sensor is set to inactive until
5 mm before the anticipated rear edge of the
material. This allows to process materials that have
e.g. a colourful surface or a hole (die cut) in them.
The paper length is controlled in this setting, so paper
jams or double feeds will be detected.
To properly use this setting, the
correct material size must be
set in the printer. Either sent by
the PC software or measured
manually.
If the material separation and
transport is not setup correctly,
turning off the paper sensor can
cause misprints.
Default:
On
Pos: 60.64 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü2/Ü2_2700_DOS_MODE @ 0\mod_1254832327765_912.doc @ 4361 @
DOS MODE
Pos: 60.65 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_2701_LINE MODE @ 0\mod_1254915736970_912.doc @ 4987 @
LINE MODE
This feature is used to set a number of lines that separate one page (address) from the
next.
0 to 36
Default:
0
Pos: 60.66 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_2702_HEX TO ASCII @ 0\mod_1254915739923_912.doc @ 5003 @
HEX TO ASCII
Conversion from HEX to ASCII.
If the conversion is switched on, the printer interprets the percentage sign “%“ as a non-
printable control character. The two characters following the % sign are interpreted as HEX
values, e.g. %0C = Form Feed.
off, on
Default:
off
Pos: 60.67 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_2703_AUTO LINEFEED @ 0\mod_1254915734173_912.doc @ 4975 @
