User Manual Version 3.1
27
5.3
How to setup the feeder
To setup the feeder you need to perform the following steps in this order:
1. Adjust
the
separation
2.
Adjust the paper side guides
3.
Fill the feeder with material
4.
Adjust the paper feed ramp
1. Adjust the
separation
•
Open the fixing screws of both separators and lift them.
•
Depending on your medium put one or two pieces under all four
separation fingers.
Thin medium (e.g. single sheets with 100 g/m²)
= two pieces under the fingers
Envelopes
= put the thickest part of the envelope (= flap) under the fingers
When using a narrow medium put two or more pieces next to each
other so that there is material under each separation finger.
Setup all separation fingers
Make sure that there is a medium under each
separation finger. Otherwise unused fingers could
wear the feed rollers (see Figure 9).
•
Drop the separation fingers so that they sit on the medium.
•
Lock both fixing screws.
•
Remove the medium.
Figure 8: Adjusting the separation
fixing screw
medium
separation
fingers
separator
