Note
The print object must lie on top of the paper recognition
.
2.
For the setting of the side guides, use the paper sensor as a benchmark. The
paper side edge should extend at least 5 mm over the paper sensor.
Illustration
5-30: Setting the directional control
If the installed side guide (2) is not sufficiently wide, then replace it with one of the
two wider guides included in the delivery (
see Illustration
4-1: PRINTER 700/710
overview
).
1.
Loosen the locating screw (4) and lift the side guide (2) out of the opening.
2.
After the side guide has been set in position, move it to the desired width and
fix it in position with the screw (4).
5.4.2.4.2
Adjust Outfeed Rollers
See
H
Illustration
4-4: PRINTER 700/710 safety cover
The outfeed rollers can be pushed sideways using the handles.
Arrange the outfeed rollers in such a way, that the print object is caught by the
rollers, but that the print area is
not
in contact with the rollers (otherwise, smear-
ing of the ink can occur).
Assure yourself of the print object setting by carrying out a
paper run without
printing
.
5.4.2.5
Setting the Paper Support Plate
Horizontal alignment
1.
With a wide, unstable print object surface, use the second guide bracket (5).
2.
Loosen the locating screw (7) and set both guide brackets (5) approximately
in the middle.
39
