HART HPSV60 20V, Руководство оператора

Страница: 7 / 24

7 – English
This product contains no serviceable parts.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
HOSE MAINTENANCE
See Figure 8, page 10.
Irregular suction may be the result of a clogged or obstructed
hose.
To clean hose:


Remove the battery pack.
 Tilt the body of the vacuum away from the roller brush
and rest it on the floor.

Depress the hose release button to eject the hose from
the roller brush.
 Remove any foreign materials clogging or restricting the
hose.

Reinstall the hose.
NOTE:
Make sure the hose is securely in place before
using.
REMOVING THE ROLLER BRUSH FOR
CLEANING
See Figures 9 - 10, page 10.
The roller brush is located inside the roller bar assembly.
To remove:
  Remove the battery pack.

Insert a coin into the slot on the end of the roller brush.
Rotate the end cap approximately 1/4 in. counterclockwise
to unlock the roller brush.
MAINTENANCE
 Slide the brush to release the cap and pull the brush from
the roller bar assembly.
NOTE: Use scissors to remove any threads or hair
wrapped around the roller brush using the scissor
grooves.
To reattach:

Insert the roller brush into the roller bar assembly.
 Align the tabs on the cap to the notches on the roller bar
assembly and firmly press the cap into place.
NOTE: Make sure the opposite end of the roller brush is
aligned to the drive spindle when pressing the cap into
the assembly housing.
 Turn the end cap 1/4 in. clockwise with coin to lock into
place.
CLEANING/REPLACING THE FOAM FILTER
See Figure 11 - 12, page 10.


Remove the battery pack and the dust bowl.


Push tab to open the lid on top of the dust bowl.

Remove the foam filter from inside the lid.

Rinse foam filter with warm water. Set aside and allow to
dry completely.

Empty the dust bowl; wash if necessary. Before reattach -
ing to the stick vac, make sure all pieces are completely
dry.
NOTE: Allow 24 hours for parts to dry completely.


Reinsert the foam filter into the lid.


Close lid, pressing firmly until lock button engages.

Reattach dust bowl.
When purchasing replacement parts, use the recommended
model number for foam filter (HASV60).
NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.